The VS3208 is Quested's largest self-powered monitor. It is also, together with the VH3208, their smallest 3-way model.
The 3-way, dual bass driver, design has the benefit of unsurpassed clarity in the mid-range together with a solid bottom end. A remote mounting kit is available for the tri-amped power module enabling the cabinet to be soffit mounted if required.

Typical applications; Broadcast, acoustic instrument recording.

Specification

Size (WxHxD) 485(w) x 612(h) x 395(d) mm
Weight 47 kgs
Drivers Bass: 2 x 200 mm (8") cone driver
Mid: 1 x 75 mm (3" soft dome)
HF: 1 x 28mm (1.125") soft dome tweeter
Maximum SPL 117dB
Frequency Response 42Hz - 20kHz +/-2 dB
Sensitivity 90.5 dB at 1W at 1m
Input Connector XLR3 Female
Impedance 10 kohm. Electronically balanced, RF filtered
Wiring Pin 1 ground Sleeve. Pin 2 hot Tip. Pin 3 cold Ring
Sensitivity Rear mounted 10 position rotary switch calibrated in 2 dB steps
Maximum +4dBu for 100dB SPL at 1m: Max input level for clip >+16dBu at 5kHz
Minimum -14dBu for 100 dB SPL at 1m: Max. input level for clip >-2dBu at 5kHz
Filters
User LF EQ 3 position rear mounted switch to select: FLAT for normal use, CUT for nominal 2dB cut below 100Hz and LIFT for nominal 2dB LF lift below 80Hz User HF EQ 3 position rear mounted switch to select FLAT for normal use, CUT for nominal 2 dB cut and lift for nominal 2 dB LF lift in the frequency band 500 - 3kHz

Power amplifier
LF output power 230W rms continuous*
Mid output power 110W rms continuous*
HF output power 100W rms continuous*
T.H.D. < 0.03% at levels up to 1 dB below clip, 20Hz - 20kHz. typ 0.005% at 20W rms 1kHz
Hum + Noise > -100 dB referred to clip
Indication
Power on Front mounted green LED indicates power applied Overload Front mounted LED (flashes red) indicates 0.5 dB below signal clip
Thermal protection Front mounted LED turns red, signal is muted and amplifier switches to standby mode during thermal protection cooling cycle.
Normal operation resumes when heatsink temperature drops by 20°C
Power requirements
Voltage Set by internal plugs: nominal 115V or 230V @ 50-60 Hz AC
230V setting: min 160V; restricted output power: max 263V
115V setting: min 80V; restricted output power: max 132V
Consumption Quiescent 105W, Typical use 280W, Max 950W